The following is an example of the process used for Automotive engines UNDER 5.0 liters of displacement.
Note: This process can be completed in just 30 minutes!
Starting with a cold engine, remove the air filter or disconnect the air intake hose between the air filter housing and the throttle body. Revive must be sprayed after (or downstream) of the air filter and the Mass Air Flow (MAF) sensor.
Spray Revive in 3 doses of 250ml into the intake, 1st with the engine running at 2200 RPM, next at 1800 RPM, stop the engine for 5 minutes, re-start the engine then finally at 2000 RPM.
Keep the engine running for a few more minutes until the Revive has worked out of the system.
Take the vehicle for a drive of about 20 minutes, this allows Revive to do its work.
It is suggested that the Revive cleaning process is performed as a preventative maintenance operation before a service, which will then allow the engine to be checked over and filled with clean oil.
Dodge Ram - Cummins 6.7L
I applied Revive then looked at the turbo and clearly the Revive product worked. The slide ring was completely clean there was zero soot built up on it at all. It would slide in and out freely, like it was new. It's clear your product does work and will definitely be using it again on the next one. I will also recommend it to my customers as a "maintenance" product every 20-30k.
Thanks for your help!!!!
Judd McClure - PBD Diesel Performance, LLC
